General Characteristics - Cembre HT-TC051 Notice D'utilisation Et Entretien

1. GENERAL CHARACTERISTICS

– Application range: the tool is suitable for cutting copper, aluminium or telephone cables having a
– Rated operating pressure: ............................................................................................... 600 bar (8,700 psi)
– Dimensions: lengt ............................................................................................................... 497 mm (19.5 in.)
width .............................................................................................................. 129 mm (5.1 in.)
– Weight: ..................................................................................................................................... 4,38 kg (9.6 lbs)
– Oil: .............................................................................................. ENI ARNICA ISO 32
– Advancing speed: the tool automatically switches from a fast advancing speed of blades to a
slower cutting speed.
– Safety: the tool is provided with max pressure valve; MPC1 special manometer, is available upon
request to check the proper setting of the valve.
2. INSTRUCTIONS FOR USE
2.1) Setting
Insert the cable between the blades at the desired cutting point.
For a running cable, press latch (28) and open the upper blade assembly.
Warning: the opening of upper blade assembly must be done when the tool is in rest position, with
the lower blade (18) completely retracted.
With the cable on the lower blade (18), close the upper blade assembly and secure the latch (28).
Before commencing the cutting operation ensure that the latch is fully secured: partial closure may
damage the tool head.
2.2) Blade advancement
Operate moveable handle (44) for lower blade advancement. This fi rst stage rapidly closes the
lower blade to the conductor. Make sure that blades (18 and 23) are exactly positioned on desired
cutting point, otherwise re-open blades following instructions as § 2.4 and re-position the cable.
3
HYDRAULIC CUTTING TOOL
HT-TC051
max. diameter of ........................................................................... 50 mm
(Ref. to Fig. 1)
SHELL TELLUS S2 V 32
ENGLISH
(2 in.)
or
or equivalent