General Characteristics - Cembre TC025 Notice D'utilisation Et Entretien

• Wear eye protection. Metal chips can fl y from blades when cutting.
• Do not cut short, unsecured pieces of steel rod or rope as they may fl y off dangerously, causing
injury to the operator or persons nearby.
• Inspect the blades before each use. Do not use damaged blades.
• Damaged blades can break and cause injury or damage to the tool.
• Work in a clean, uncluttered area. Keep persons away from immediate work area.
• Use this cutting tool for the manufacturer's intended purpose only.
• Do not cut live cables or conductors.

1. GENERAL CHARACTERISTICS

– Application range: suitable for cutting steel ropes and conductors having a max ø of 25 mm
– Max operating pressure: .............................................................................................. 700 bar (10,000 psi)
– Oil necessary (displacement): ..................................................................................... 22 cm
– Dimensions: length ........................................................................................................ 213 mm (8.4 in.)
width .......................................................................................................... 87 mm
– Weight: ................................................................................................................................. 2,0 kg
2. INSTRUCTIONS FOR USE
2.1) Setting
(Ref. to Fig. 3)
The head is equipped with a "self-lock" quick male coupler suitable for connection to a hydraulic,
pneumatic or electric pump from the Cembre range.
Insert the conductor between the blades, up to the desired cutting point. For a running conductor,
release the latch (16) and open the tool head.
Fully retract the lower blade (15) before attempting to open the tool head.
With the cable on the lower blade (15), close the tool head and fully secure the latch (16).
Before commencing the cutting operation ensure that the latch (16) is fully secured: partial
closure may damage the tool head.
2.2) Blade advancement
Operate the pump to advance the lower blade.
Make sure the blades are exactly positioned on the desired cutting point; otherwise retract the
lower blade, as § 2.4 and re-position the cutting head.
3
HYDRAULIC CUTTING HEAD TC025
(1 in.) (see TABLE 1 page 5).
WARNING
ENGLISH
3
(1.34 cu. in)
(3.4 in.)
(4.4 lbs)