Husqvarna HA322 Manuel D'utilisation page 9

7. Make sure that the handle and safety
features are in good working order. Never
use a product that lacks a part or has been
modified outside its specifications.
To operate the product
1. Work with a swinging action from the
bottom upwards when trimming sides.
2. Adjust the throttle/speed setting to suit the
load.
3. When you use a gasoline operated product
to cut a hedge, make sure the engine
faces away from the hedge.
4. Do not rush the work, but work steadily
until all the branches have been cut back
cleanly.
To change the hedge trimmer angle
1. Stop the product.
2. Put the product on the ground and install
the transport guard (A) to the cutter.
A
3. Move the angle adjustment lever (B) away
from the attachment to remove the pin (C)
from its hole.
B
1917 - 003 - 03.11.2023
D
C
Note:
It the pin does not move smoothly,
move the shaft (D) back and forth a little.
4. Use the angle adjustment handle (E) to
adjust the angle of the cutter.
5. Release the angle adjustment lever to lock
the pin (C) in its correct hole.
E
C
9