Husqvarna HA322 Manuel D'utilisation page 8

To install the harness support hook
1. Install the harness support hook between
the loop handle and the throttle handle.
Note:
Do not put the support hook on the
decal.
2. Tighten the 2 screws with the hex key.
3. Adjust the ring to make the product
balanced, and easy to use.
To assemble the cutting head
1. Remove the set screw from the cutting
head.
To do a check before start
1. Examine the work area. Remove any
objects that could be thrown out.
2. Examine the cutting attachment. Do not
use blades that are damaged.
3. Examine that the product is in perfect
working order. Examine that all nuts and
screws are tight.
8
Assembly
2. Align the arrow on the shaft to the hole on
the cutting head.
B
3. Push the shaft into the cutting head until
you see the hole (A) through the cutting
head.
4. Install and tighten the set screw (B).
5. Tighten the clamp screws (C).
Operation
4. Make sure the gear housing is
lubricated correctly. See
transmission housing and gear housing on
page 10 for instructions.
5. Examine that the cutting attachment stops
when the throttle/power trigger is released.
6. Only use the product for the purpose it was
intended for.
A
C
To lubricate the
1917 - 003 - 03.11.2023