Scheppach HCE1600 Traduction Des Instructions D'origine page 27

- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
13. Troubleshooting
Fault
Device does not work
The motor starts but there is
no build up of pressure
Irregular operating pressure
Cause
No electrical voltage at the
device.
Cross section of the extension
cable not large enough and/or
the extension cable is too long.
The mains voltage is lower than
that specified.
The pump is frozen.
Air intake in the water inlet.
Discharge nozzle is too large.
Air intake in the water inlet.
www.scheppach.com
Remedy
Check the fuse, power cable and power
plug and have them replaced by qualified
personnel if necessary.
Use extension cables with larger cross
sections and/or use shorter extension
cables.
Contact the power supply company if
necessary.
Check and thaw if necessary.
Check the supply hose and hose connec-
tion and replace if necessary.
Check and replace if necessary.
Check the supply hose and hose connec-
tion and replace if necessary.
GB | 27