Kohler K-1913 Guide Du Propriétaire page 5

Toe Tap Drain
Door Switch
Handle
Operating Your Bath
Using the Bath
NOTE: A removable label is included with the literature packet. It should be applied over the door switch
as a reminder on how to operate the bath.
With the door lowered, turn on the water and adjust it to the desired temperature. The water will
run into the footwell and exit through the sidewall drain and toe tap drain (if open) until the door
is closed.
Enter the bath and close the toe tap drain located in the footwell.
Lightly grasp the handle recess and raise it until the latches on each side of the door engage. The
drain valve will close and the seal will begin inflating.
IMPORTANT! If water does not cover the level sensors within 2 minutes, the drain valve will open
automatically.
Immediately add water to the bath until it is above the level sensors.
Fill the bath until the water is just below the overflow drain.
Exiting the Bath
Push the door switch and open the toe tap drain. The water will drain from the bath in
approximately 2 minutes.
When the water level is below the level sensors, the door seals will automatically deflate. Periodic
cleaning of the sensors will improve response time.
To lower the door, grasp the handle and squeeze while lightly pushing down.
If the bath does not function properly, please refer to the "Troubleshooting" section.
Kohler Co.
All manuals and user guides at all-guides.com
Level Sensors
Label
1 - To Drain
Press button once
and
press floor drain
2 - To Exit
When drained,
lift latch on outside
of rising wall
5
Sidewall Drain
Footwell
1128532-5-G