Télécharger Imprimer la page

Hartan Racer GT Manuel D'instructions page 21

Masquer les pouces Voir aussi pour Racer GT:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
All manuals and user guides at all-guides.com
Instructions
WARNING!
In case the carrycot
is attached to the frame, the footre-
st should always be in horizontal
position, as an additional protection
preventing it from slipping out. Secure
the carrycot according to the operating
instructions.
G
Automatic lock for upper section 19
D
Place the carrycot or stroller unit upon
the chassis in a way that the two
lateral pins engage in the respective slots on each side. Then push the
upper section right up to the stop. The catching pins on both sides enga-
ge auto matically, which is indicated each time by a click sound.
WARNING!
By pulling the upper section horizontally, check before
use whether it is fixed correctly! If the red safety point can still be seen,
the upper-section lock has not yet completely closed! Pull the locking
lever downwards until it snaps into place to open the lock and to remove
the upper section.
Fall-out protection
WARNING!
As an additional protection pre-
18
venting the baby from falling out
of the carriage, secure the hood
17
17
to the metal back. To do this,
join the two grommets 17 to their
respective turn-lock fasteners,
13
and the hook lock 18 to the metal
ring on the back plate as well.
Adjusting the backrest
By raising adjustment lever 13 on the back, the seat-back can be precise-
ly adjusted to any incline between an upright seated position and a lying
WARNING!
position.
When adjusting the backrest, take care that no
movable parts jam the baby's limbs, or fingers, etc. Finally, make sure the
backrest has reengaged properly.
17

Publicité

loading