EINHELL GE-CM 18/33 Li Instructions D'origine page 26

10. Troubleshooting
Fault
The motor fails to
start
The motor perfor-
mance drops
Cutting is irregular
Anl_GE_CM_18_33_Li_SPK13_3413261.indb 26 Anl_GE_CM_18_33_Li_SPK13_3413261.indb 26
GB
Possible causes
a) The connectors have become
separated from the motor or the
capacitor
b) The mower is standing in high
grass
c) The mower housing is clogged
d) Safety switch is not inserted
e) Battery is not correctly inserted
a) The grass is too high or too damp
b) The mower housing is clogged
c) The blade is severely worn
d) Battery performance decrea-
sing
a) The blade is worn
b) Wrong cutting height
- 26 -
Remedies
a) Have repaired by the Customer
Service Center
b) Start in low grass or on an area that
has already been mowed; change
the cutting height if necessary
c) Clean the housing so that the blade
moves freely
d) Insert safety switch (see 6.)
e) Remove the battery and reinsert
(see 5.)
a) Correct the cutting height, change
the electronics setting
b) Clean the housing
c) Replace the blade
d) Check the battery performance
and charge the battery if necessary
(see 5.)
a) Replace or resharpen the blade
b) Correct the cutting height
03.08.2023 15:01:51 03.08.2023 15:01:51