TechniSat DIGITRADIO Bike 1 Manuel D'instructions page 19

4.3 Preparing the DIGITRADIO Bike 1 for operation
4.3.1 Charge battery
Before using the DIGITRADIO Bike 1 for the first time, you should first fully charge the
battery.
Make sure that the operating voltage of the power supply unit matches the
local mains voltage before plugging it into the wall socket.
WARNING!
Do not touch the mains plug with wet hands, risk of electric shock!
ATTENTION!
Lay the mains cable so that nobody can trip over it.
Connect the supplied mains adapter to the socket labelled DC-IN (1) on the
>
back of the DIGITRADIO Bike 1. To do this, lift the protective cover of the
socket and fold it upwards. Then connect the power supply unit to the mains.
19