Black & Decker BCW201 Mode D'emploi page 12

ENGLISH
Warning: To reduce the risk of
serious personal injury, always hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on
the main handle (2) .
Note: Do not rest fingers on sanding base
during use. Move the sander in long
sweeping strokes across the surface, letting
the tool do the work. Light pressure is all
that is required for sanding, polishing or
scrubbing. Excessive pressure will slow the
tool and produce inferior results. Check
your work often, product is capable of
removing material rapidly
Fig. H
Warning: Shock hazard. Under no
circumstances should this product
be used near water.
Caution: To reduce the risk of injury,
turn o and remove the battery
from the tool before making any
adjustments or removing or installing
attachments or accessories.
Switching on and o
1. To switch the tool "ON", depress the
on/o switch 1 at the side position I.
2. To switch the tool "OFF", depress the
on/o switch 1 at the side position O.
12
(Original instructions)
Fig. I
2
Fitting sanding sheet (Fig. I)
Warning: Remove battery when
removing or installing the sanding
sheet.
1. Hold the tool with the sanding base
facing upwards.
2. Place the sanding sheet (12) onto the
sanding base with the grit facing up.
12
Rotating the sanding base (Fig. J)
Warning: Remove battery when
removing or installing the sanding
base.
The sanding base (3) can be rotated if a
corner becomes worn.
1. Hold the tool with the sanding base
facing upwards.
2. Unscrew the screw that holds the sanding
base to the sander.
3. Rotate the sanding base so that an
unworn corner faces forward. Make sure
the sanding base is properly seated.
4. Secure the sanding base by inserting and
tightening the screw.