Télécharger Imprimer la page

Black & Decker BCW201 Mode D'emploi page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
Note: The state of charge indicator will face
the rear of the tool and the USB ports will
face the front. The arrow on the battery will
align with the arrow on the tool as shown in
Fig. E.
3. Snap the BLACK+DECKER GoPak 2 in 1
battery into the foot of the tool. The
arrow (13) on the battery will align with
the arrow (14) on the tool. Ensure the
battery is fully seated and fully latched
into position before using.
4. To remove the BLACK+DECKER GoPak 2
in 1 battery from the tool, depress the
two battery release buttons (5) located
on the tool and pull the BLACK+DECKER
GoPak 2 in 1 battery o the tool.
Note: The BLACK+DECKER GoPak 2 in 1
battery USB ports are disabled when the
trigger is pulled.»
Fig. F
14
13
Using the GoPak 2 in 1 battery to
charge your USB device (Fig. G)
1. Plug the USB A end of your device
specific cable (11) into the
BLACK+DECKER GoPak 2 in 1 battery
(10) and the other end of the cable into a
UL or CSA listed compatible device
(Phone/Tablet/MP3/Wearable/Game
Controller/etc.). Charging will start
automatically.
(Original instructions)
5
4
Fig. G
11
Functionality
The BLACK+DECKER GoPak 2 in 1 battery
can power your compatible BLACK+DECKER
12 V GoPak MAX* tools or power/charge
your mobile devices. The compact, slim
battery housing is designed for portability.
- GoPak Charge Input: Up to 2.4A**
- GoPak Power Output: Up to 2.4A***
** Actual input charge rate is dependant
upon power adapter (not included).
***Actual output rate is dependant on the
device.
USB power port
The BLACK+DECKER GoPak 2 in 1 battery is
equipped with a USB Type A power port. It
delivers up to 2.4 amp total current.
Note: The current delivered to device is
dependent on user device and user's chosen
cable.
Warning: Ensure the terminal cap is
securly attached to the
BLACK+DECKER GoPak 2 in 1
battery when using it to power/charge your
device.
• Install terminal cap on the tool terminals.
• Device charging from USB will start
automatically when device is connected.
• To turn OFF, disconnect USB device.
Proper hand position (Fig. H)
Warning: To reduce the risk of
serious personal injury, ALWAYS use
proper hand positionx as shown.
ENGLISH
10
11

Publicité

loading