Black & Decker BCW201 Mode D'emploi page 10

ENGLISH
To actuate the state of charge, press the
state of charge Indicator button. A
combination of the four LEDs will illuminate
designating the level of charge left. When
the level of charge in the battery is below
the usable limit, the state of charge LEDs
will either not light or the bottom LED will
blink.
Note: The LED state of charge will only
display once the state of charge button is
pressed.
Fig. D
• Press state of charge button at anytime
to display the remaining level of charge.
Note: The state of charge Indicator is only
an indication of the charge left on the
battery. It does not indicate tool
functionality and is subject to variation
based on product components, temperature
and end-user application.
Note: GoPak battery terminal cap should be
used when battery is not connected to a
power tool. Terminal cap is provided for use
whenever the battery is out of the tool.
Remove cap before placing battery into
tool.
Save these instructions for
future use
Components (fig. A)
Warning: Never modify the power
tool or any part of it. Damage or
personal injury could result.
Refer to Figure A at the beginning of this
manual for a complete list of components.
Assembly and adjustments
Warning: To reduce the risk of
10
(Original instructions)
8
serious personal injury, azunit o and
remove the battery pack before
making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
GoPak tool terminal cap
A battery storage and carrying cap (9) is
provided for use whenever the battery is out
of the tool. Remove the cap as shown in
Figure E before placing battery onto tool.
Fig. E
Operation
Warning: To reduce the risk of
serious personal injury, turn unit o
and remove the battery pack before
making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
Installing and removing the GoPak 2
in 1 battery in a power tool (Fig. F)
Warning: Remove any connected USB
cords from the BLACK+DECKER
GoPak 2 in 1 battery before
connecting the GoPak to the
compatible tool.
1. Remove the tool terminal cap if installed
on the BLACK+DECKER GoPak 2 in 1
battery.
2. To power a compatible GoPak 12V MAX*
power tool, align the tool terminals on the
foot of the tool with the terminal slots on
the battery (4) as shown in Fig. E.
9