CMi H-EKS 2000/40 Mode D'emploi page 57

All manuals and user guides at all-guides.com
Kettensaege_Elektro_302128.book Seite 57 Donnerstag, 5. Januar 2017 4:59 16
The bearing of the chain wheel should be
regularly lubricated at the front-end of the
rail. About 1× in a week in case of intensive
use.
– Clean the lubrication hole.
– Apply little multi-purpose grease in the
lubrication hole, while moving the chain
with hand.
Sharpening the saw chain
DANGER! Danger of death! A worn
or improperly sharpened chain can
cause rebounds. Severe or even fatal
injuries can be the result!
Note: Special tools are required to
sharpen the saw chain; these guar-
antee that the cutting of the chain
occurs at the correct angle and the
correct depth. We recommend that
you have the saw chain sharpened
by a professional.
Storage and transport
Storage
DANGER! Risk of injury! Make sure
that unauthorized persons do not
have access to the device!
• Let the device cool down before you
store it.
Fault/malfunction
Motor not running.
If you can't fix the fault yourself, contact your
nearest vendor. Please be aware that any
improper repairs will also invalidate the war-
ranty and additional costs may be incurred.
Disposal
Disposal of the appliance
Appliances which are labelled with
the adjacent symbol must not be dis-
posed of in household waste. You
must dispose of such old electrical
and electronic equipment separately.
– Please check with your local authority
about the possibilities for correct dis-
posal.
Longer downtimes
If you are not going to be using the device for
a while, remove the chain oil from the device.
Store the device in a dry place.
Transport
If you are transporting the device in a vehicle:
Faults and remedial measures
When something isn't working...
Malfunctions are often caused by minor
faults. You can easily remedy most of these
yourself. Please consult the following table
before contacting the vendor. You will save
yourself a lot of trouble and possibly money
too.
Cause
No mains voltage?
Cable faulty?
Through separate disposal you send old
equipment for recycling or for other forms of
re-use. You will thus help to avoid in
some cases that damaging material gets into
the environment.
Disposal of the packaging
The packaging consists of card-
board and correspondingly marked
plastics that can be recycled.
Technical data
Item number
Nominal voltage
Nominal output
• Store the device as horizontally as possi-
ble.
– Slip the protective cover onto the cutting
tool.
– Secure the device against slipping.
– If possible, use the original packaging for
dispatching.
DANGER! Risk of injury! Improp-
erly performed repairs can lead to the
device not functioning safely. This
endangers yourself and your envi-
ronment.
Remedial measure
Check cable, plug, socket and
fuse.
Have replaced by an electri-
cian.
– Make these materials available
for recycling.
GB
302 128
230-240 V~,
50 Hz
2000 W
57