Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Kettensaege_Elektro_302128.book Seite 50 Donnerstag, 5. Januar 2017 4:59 16
GB
• Do not overreach and do not cut above
shoulder height. This helps prevent
unintended tip contact and enables bet-
ter control of the chain saw in unex-
pected situations.
• Only use replacement bars and chains
specified by the manufacturer. Incor-
rect replacement bars and chains may
cause chain breakage and/or kickback.
• Follow the manufacturer's sharpening
and maintenance instructions for the
saw chain. Decreasing the depth gauge
height can lead to increased kickback.
Additional safety information
• It is recommended that the user is
instructed by a qualified specialist with
regard to the operation of the chain saw
and the use of safety equipment based
on practical examples prior to first com-
missioning.
• This product is not intended to be used
by persons (including children) or who are
limited in their physical, sensory or men-
tal capacities or who lack experience
and/or knowledge of the product unless
they are supervised, or have been
instructed on how to use the product, by
a person responsible for their safety.
• Children should be supervised to ensure
that they do not use the product as a toy.
• Children and adolescents are not allowed
to operate the chain saw. The same
applies to persons who are not or not well
enough acquainted with the chain saw.
• The operating instructions should always
be within easy reach.
• Persons suffering from fatigue or who are
not physically fit must not operate the
chain saw.
• Keep the handles dry and free from
grease. Slippery handles can cause
accidents.
• Keep a firm hold of the electrical tool
with both hands while working and
make sure you are standing firmly.
The electrical tool is more safely guided
using two hands.
• Do not leave tools, objects or cable
laying around in the vicinity of the
device. If you stumble, you may injure
yourself on the power tool.
• Make sure that all safety facilities and
handles are mounted when using the
product.
50
• Never attempt to operate an incompletely
mounted product or a product with
impermissible modifications.
• Wait until the electrical tool has come to
a standstill before putting it down.
• Do not use any accessory that has not
been provided and recommended by
the manufacturer specially for this
electrical tool. Just because the acces-
sories can be fixed on your electrical tool,
no secured use is ensured.
• Remember that moving parts may also
be located behind ventilation and venting
slots.
• The fuse must be a residual current cir-
cuit-breaker with a measured residual
current of no more than 30 mA.
• Lay out the cable such that it cannot
become caught in branches or similar
during sawing.
• Beginners should at least first practice
cutting round wood logs positioned on a
saw block or on a frame.
• If the power supply cable is damaged, it
must be replaced with a specially
equipped cable, which is available from
the customer service organisation.
• Changing of the plug or the power supply
cable must always be carried out by the
manufacturer of the electric tool or by a
manufacturer's service.
• Symbols appearing on your product may
not be removed or covered. Information
on the product that are no longer legible
must be replaced immediately.
Observe the safety instructions be-
fore using the product for the first
time.
Read and observe the operating
instructions before commission-
ing.
Protect the device from wet condi-
tions. Store in a dry location.
Remove the plug from the mains
immediately if the cable is dam-
aged or cut.
Area with a danger of kickback
Always hold the device firmly in
both hands.
Wear hearing protection.
Publicité
