CMi H-EKS 2000/40 Mode D'emploi page 52

All manuals and user guides at all-guides.com
Kettensaege_Elektro_302128.book Seite 52 Donnerstag, 5. Januar 2017 4:59 16
GB
Note: If one of the parts should be
missing or damaged, please contact
the vender.
Assembly
DANGER! Risk of injury during
operation! Improperly mounted
parts can cause severe and even
fatal injuries when using the device!
This device may only be commis-
sioned if all parts are mounted com-
pletely and tightly and no part is
damaged!
• Therefore, read the whole chap-
ter before you assemble the
parts!
• Assemble the parts carefully and
completely.
• Use tools when their use is sug-
gested.
WARNING! Risk of injury during
assembly! Parts may only be
assembled and disassembled when
the motor is switched off (de-ener-
gise device).
CAUTION! Risk of injuries due to
cuts! The teeth of the saw chain are
very sharp! Protective gloves must
be worn for all work on the chain.
DANGER! Risk of injury! An
improperly mounted saw chain
causes uncontrolled cutting behav-
iour of the device! When assembling
the chain, heed the prescribed run-
ning direction!
Assembling the saw rail and saw chain
– Loosen the screw (4) on the chain wheel
guard (5) and remove chain wheel guard
(► P. 4, item 3).
– With the spanner (15), turn the bolt (16)
towards the front (► P. 4, item 4).
– Place Saw rail (3) on the guide rail (17)
with the guide groove (18) (► P. 4,
item 5).
Note: When attaching the chain,
heed the correct position of the guide
groove (saw rail).
– Place the saw chain (2) around the chain
wheel (19). Heed the assembly direction.
52
– Place the saw chain (2) around the saw
rail (3).
– Attach the chain wheel guard (5).
– Tighten the fastening nut (4) only slightly.
Tensioning the saw chain
► P. 5, item 7
– Tighten the tension ring (15) until the
chain lies on the underside of the saw rail.
– Tighten the fastening nut (4).
Letting the saw chain run in
During the run-in time, re-tension the saw
chain and rail after a maximum of 5 cuts.
Checking the tensioning of the saw chain
WARNING! Risk of injury! A new
saw chain must be re-tensioned after
a maximum of five cuts. This is nor-
mal during the run-in time; the inter-
vals between subsequent re-tension-
ings will get larger.
The saw chain is tensioned correctly if it lies
close against the underside of the saw rail
and can be moved easily by hand.
Readjust tension of the saw chain when nec-
essary (► Re-tensioning the saw chain –
p. 56).
Checking the chain greasing
NOTICE! Device damage! The
device may not be used without suf-
ficient chain greasing. Insufficient
greasing reduces the service life of
the device.
– Check the oil quantity in the tank.
– Start the device.
– Hold the running saw chain approx. 15
cm over a suitable surface for a time
(15 s).
If there is sufficient chain greasing, the oil
spraying off of the saw chain will form a slight
trail.
Checking the chain brake
The chain brake ensures immediate blocking
of the saw chain in case of a rebound. Before
beginning work with the device, it must be
checked to ensure that it is functioning cor-
rectly.
– Set device on the ground.
– Start the device.
– Tip the hand guard forwards. The chain
must stop immediately.
– If the chain brake is not working correctly,
have the device checked by an expert
immediately.