CMi H-EKS 2000/40 Mode D'emploi page 56

All manuals and user guides at all-guides.com
Kettensaege_Elektro_302128.book Seite 56 Donnerstag, 5. Januar 2017 4:59 16
GB
NOTICE! Device damage! Make
sure that the saw rail does not touch
the ground while you are sawing
through the trunk!
Propped-up trunks
We recommend that you place trunks to be
sawed through on sawhorses. If this is not
possible, the trunk should be lifted with the
help of supporting branches and placed over
trestles.
A
In area A, first cut through approximately one
third of the trunk diameter from above down-
wards, then make the final cut from below
upwards. In area B, first cut through approx-
imately one third of the trunk diameter from
below upwards, then saw through from
above.
DANGER! Risk of injury! Do not
saw any trunks under tension! Splin-
tering wood or a twisted saw rail can
cause extremely severe injuries!
Removing branches
• Always work on the side opposite the
branch in question.
• Begin at the bottom of the trunk and work
upwards.
• Always guide the saw from above down-
wards through the wood.
When removing the branches from trunks
which are lying down, first saw off the free
branches sticking up in the air. Only saw off
supporting branches when the trunk is
sawed in lengths.
DANGER! Risk of injury! Branches
that are high up or under tension can
wedge the saw chain in the wood!
Cleaning and maintenance
DANGER! Risk of injury! Before
any maintenance or cleaning work:
– Pull out the plug.
– Let the device cool down.
56
DANGER! In the interest of your
own safety! Only perform the main-
tenance work described here your-
self.
Any other work, especially motor
maintenance and repairs must be
performed by a trained professional.
Improper work can cause damage to
the device and thus also injuries.
Cleaning and maintenance overview
After each use
B
What?
Clean the device
Regularly, depending on the conditions of
use
What?
Re-tension saw chain ► Re-tensioning the
Clean oil guide
groove of the saw rail.
Sharpen the saw
chain.
Cleaning
Cleaning the device
– Remove coarse dirt.
– Wipe down the device with a slightly
damp cloth.
Cleaning the oil guide groove of the saw
rail
NOTICE! Device damage! To clean
the saw rail, use only a plastic spat-
ula, never a steel tool.
– Remove the saw rail.
– Clean dirt from the oil guide groove of the
saw rail with a suitable tool.
– Replace saw rail(► Assembling the saw
rail and saw chain – p. 52).
Re-tensioning the saw chain
► P. 5, item 7
– Loosen the fastening nut (4) by approxi-
mately one turn.
– Lift the tip of the saw rail slightly.
– Tighten the tensioning screw for chain
tension (15) until the chain lies on the
underside of the saw rail.
Lubricating chain wheel
► P. 6, item 11
How?
► Cleaning the de-
vice – p. 56
How?
saw chain – p. 56
► Cleaning the oil
guide groove of the
saw rail – p. 56
► Sharpening the
saw chain – p. 57