Worx WG102 Mode D'emploi page 10

rotate after the trimmer has been switched off.
Wait until it stops before laying the trimmer
down.
OPERATION
Warning: Always wear eye protection
and heavy clothing to prevent rocks and
debris from hitting you and causing an eye
injury or other serious injuries. Use two hands
operate the trimmer and hold the unit below
waist level.To best ensure that debris is thrown
away from your body, work only from the right
to left. For optimal trimming and edging results.
While maintaining comfort, keep the trimmer
head parallel to the ground when trimming
(perpendicular, when edging). When trimming
be sure to keep sufficient distance between the
cutting line and the ground.
Warning: Before operating, make
sure both trimmer lines are extended.
When trimming, make sure motor is
running at full speed.
Warning: Use only 0.065" (1.65mm)
diameter cutting line. Other line sizes
10
will not properly feed in the trimmer head
and could cause serious injury. Never use
other materials such as wires, string or
rope, as this may break off during cutting
and cause serious injury.
TRIMMING
Hold the bottom of the trimmer head about 3
inches above the ground and at an angle. Allow
only
the tip of line to make contact. Do not force
trimmer line into work area.
EDGING (See H)
Unscrew the upper adjustment knob (3), rotate
the main and auxiliary handle 90º, and retighten
the knob. Adjust trimmer head angle so that it is
in line with the shaft (horizontal). Put the wheel
on the ground to begin edging, using the white
line guides to indicate the cutting position at the
edge of your lawn. While edging, allow the tip
of the line to make contact. Do not force the line.
Grass/Edge trimmer
Trilingual-WG102-M-060609.indd 10
All manuals and user guides at all-guides.com
The wheel helps prevent the unit from touching
the ground. Take extra caution while edging as
objects can be thrown from the trimmer line.
AUTOMATIC LINE FEED SYSTEM
When initially switching on the trimmer, a small
length of line is fed out. A 'clattering' noise will
be heard for a short time. This is normal and is
caused by the line being cut by the line cutter.
Once the line is cut to the correct length, the
'clattering' noise will stop and the trimmer
motor will run at full speed. To feed more line,
stop the trimmer completely, then restart,
allowing the motor to reach full speed. Repeat
this until you hear the 'clattering' noise of the
line cutting. (Do not repeat this procedure more
than 6 times)
REMOVING THE CAP TO MANUALLY FEED
THE LINE (See I)
Press and release manual line feed button
(16), whilst gently pull out the lines until
the lines reaches the line cutter. When the
required amount of line is fed out, gently pull
on the second line (there is no need to press
the manual line feed button again). If the line
extends past the line cutter, too much line has
been fed out. If too much line is fed out, remove
the spool cap and click the spool anti-clockwise
until the line is at the desired length.
REMOVING THE CAP
Press and hold in the two latches (12) (See
J).Pull cap away from the spool holder. Keep
the cap and spool holder clean from debris. To
replace the cap, press it firmly towards the spool
holder. Ensure that it is correctly connected by
trying to remove it without depressing the two
latches.
CHANGING THE LINE SPOOL:
First take off the cap and remove the old spool.
Place the new spool into the cap and make sure
the spool is in line with the trimmer's eyelets.
Feed one line through the eyelet, then repeat
for second line. Reattach the cap.
Warning! Your Trimmer is designed to
only use line with a maximum diameter
of 0.065" .Only use nylon line.
ENG
2006-6-9 16:56:29