DeWalt DW875 Mode D'emploi page 22

E N G L I S H
or other defective parts repaired or replaced as
instructed.
Do not use the tool if the switch is defective.
Have the switch replaced by an authorized
D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Package contents
The package contains:
1 Chopsaw
1 Quick adjusting material clamp
1 Cutting disc
1 Spanner
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your professional D WALT Chopsaw is a high
E
precision Power Tool for (angular) cutting of steel,
aluminium, synthetic materials and stone.
1 ON/OFF-switch
2 Control handle
3 Carrying handle
4 Guard
5 Spindle lock
6 Quick adjusting material clamp
7 Motor housing
8 Chain
9 Cutting table
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
en - 3
All manuals and user guides at all-guides.com
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
• Only fit 13 Amperes BS1363A approved plugs
• The cable wire colours, or a letter, will be marked
• Before replacing the top cover of the mains plug
For 115 V tools, use plugs in conformity with
BS4343.
For 115 V tools, use plugs to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
size is 1.5 mm
When using a cable reel, always unwind the cable
completely.
Also refer to the table on the next page.
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
with bared copper conductors is dangerous if
engaged in a live socket outlet.
fitted with the correctly rated fuse (1).
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
2
.
.
14