Boneco U7135 Mode D'emploi page 18

Unpacking
• Carefully remove the unit from its box.
• Remove the unit from the plastic bag.
• Warning: the mist outlet is packed in a red bag inside
en
the box insert. Make sure that you remove the mist
outlet from the packaging.
• Review the information given on the rating plate about
the mains supply.
• Use the original packaging for storing the appliance if
you do not use it all year round.
Putting into operation
Find the ideal location for your appliance:
• Do not place it directly next to a radiator or on a floor
with underfloor heating. The moisture in the mist can
damage the floor surface (6 and 7) (see Safety Instruc-
tions).
• The mist outlet must not be pointed directly at plants
or other objects. Keep a distance of at least 50 cm)
(10).
• Soak the demineralisation cartridge in a bowl of water
for at least 24 hours before using it. The resin has to
absorb water to achieve full performance.
• On average the demineralisation cartridge should be
replaced every 2 – 3 months. This interval can be shor-
ter or longer depending on the hardness of your water.
• Read the instructions under «Filling the Tank» for filling
the water tank (12).
• Place the water tank onto the base and insert the mist
outlet (13).
• Insert the plug into the mains socket and switch on the
appliance using the on/off switch (15).
• The appliance will reach full capacity about 10 to 15
minutes after been switched on.
• Make sure that the power cord is not pinched
anywhere (9). Do not operate the appliance if the cord
is damaged (2).
18
All manuals and user guides at all-guides.com
Description of the appliance
Mist outlet (rotating)
Evaporation chamber
Water tank
Demineralisation cartridge
Water tank cap
Brush
Water base
Control panel
Lower part
Water level sensor
Membrane
®
Ionic Silver Stick (ISS)
(optional)
Power plug
Air inlet
Filling the tank
Always switch off the appliance before removing
the water tank. Do not reach inside the nebuliser
space while the appliance is running!
Do not operate the appliance when the water tank is empty!
When the water reaches the minimum level, the unit swit-
ches off automatically.
• Make sure that there are no foreign objects inside the
water tank.
• Remove the water tank cap from the tank (11) (War-
ning: mist outlet is loosely inserted!). Fill the tank with
clean, cold tap water (12). Close the cap of the water
tank securely! Place the water tank onto the base and
insert the mist outlet (13). Do not add any additives to
the water (14)!
• Insert the plug into the power socket and switch on the
appliance (15).