Sony CDP-XA20ES Mode D'emploi page 5

UK model
CD player
LINE OUT
L
R
Other models
CD player
LINE OUT
FIXED VARIABLE
L L
R R
• If you have an analog power amplifier (except for UK
model)
Connect the amplifier via the VARIABLE LINE OUT jacks
using the supplied audio cord. You can adjust the output
level with the LINE OUT/PHONE LEVEL control on the
player or the LINE OUT LEVEL buttons on the remote.
CD player
LINE OUT
FIXED VARIABLE
L L
R R
Note
You cannot adjust the output level by pressing the LINE
OUT LEVEL buttons on the remote when using the UK
model.
o When making digital hookups
You can avoid deterioration of the signal during
transmission, since the music signal output through
the digital output connectors retains digital form.
You can connect a digital component such as a
digital amplifier, D/A converter, DAT or MD. When
you connect a DAT or MD, you can make digital
recordings from CDs.
Note that you cannot use fading in or out function
(page 15) when making this connection.
• If you have a digital component with an optical digital
input connector
Connect the component via the DIGITAL OUT (OPTICAL)
connector using the optical cable (not supplied). Take off
the cap and plug in the optical cable.
European and UK models
Amplifier
INPUT
CD
L
R
Other models
Amplifier
INPUT
CD
L
R
• If you have a digital component with a coaxial digital
Amplifier
INPUT
CD
L
R
Note
When you connect via the DIGITAL OUT connector, noise
may occur when you play CD software other than music, such
as a CD-ROM.
Setting the voltage selector (voltage
selector equipped models only)
Check that the voltage selector on the rear panel of the
player is set to the local power line voltage. If not, set
the selector to the correct position using a screwdriver
before connecting the AC power cord to a wall outlet.
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
Removing the notice sheet
The notice sheet is put on the player. Remove the sheet
before you use your player.
Getting Started
CD player
DIGITAL OUT
OPTICAL COAXIAL
CD player
DIGITAL OUT
OPTICAL
input connector (European and UK models only)
Connect the component via the DIGITAL OUT (COAXIAL)
connector using the coaxial cable (not supplied).
CD player
DIGITAL OUT
OPTICAL COAXIAL
110 - 120 V 220 - 240 V
Digital component
DIGITAL IN
OPTICAL
Digital component
DIGITAL IN
OPTICAL
Digital component
DIGITAL IN
COAXIAL
EN
5