Husqvarna 535iFR Manuel D'utilisation page 10

decreases the vibration from the cutting attachment to
the handlebar and handles.
1. Stop the product.
2. Do a visual check for deformation and damage, for
example, cracks.
3. Push the anti-vibration suspension lightly and make
sure that it can move slightly in all directions.
To do a check of the quick release function
WARNING: Do not use a harness with a
defective quick release function.
1. Stop the motor.
2. Do a visual check for damage for example, cracks.
3. Release and attach the quick release mechanism to
make sure that it operates correctly.
4. If the harness has a hip pad and a hip strap, make
sure that the quick release function operates
correctly.
To do a check of the cutting attachment guard
WARNING: Do not use a cutting attachment
without an approved and correctly attached
cutting attachment guard. Always use the
recommended cutting attachment guard for
the cutting attachment that you use, see
10
Accessories on page 29 . If an incorrect or
faulty cutting attachment guard is attached
this can cause serious personal injury.
The cutting attachment guard stops objects that ejects in
the direction of the operator. It also prevents injuries that
occur if you touch the cutting attachment.
1. Stop the product and remove the battery.
2. Do a visual check for damages, for example cracks.
3. Replace the cutting attachment guard if it is
damaged.
To attach and remove the locknut
WARNING: Stop the product and remove
the battery, use protective gloves and be
careful around the sharp edges of the
cutting attachment.
A locknut is used to attach some types of cutting
attachments. The locknut has a left thread.
• To attach, tighten the locknut in the opposite
direction to the direction of rotation of the cutting
attachment.
• To remove the locknut, undo the lock nut in the
same direction as the cutting attachment rotates.
• To loose and tighten the locknut, use a socket
spanner with a long shaft. The arrow in the picture
shows the area where you should operate the socket
spanner.
WARNING: When you loose and tighten
the locknut there is a risk of injury from
the teeth of the saw blade. You should
therefore always ensure that your hand
609 - 003 - 11.12.2019