Avtech IP CAMERA Serie Guide D'opération page 24

3.2.13 Network Share (For selected models only)
This function is used to assign a location in the LAN environment to save the snapshot of events.
Note: This function is available only for Windows operating systems.
The information you set here will be applied when "Network Share" is selected in "Trigger" → "Snapshot" →
"Storage Mode".
To use this function, make sure:
A PC is installed in the same LAN environment as this camera, and you know the IP address of the PC.

A PC account is created as "Administrator" with a user name and password.

A folder in the PC is opened as shared to the user account you assigned.

Note: Please check "APPENDIX 9 PREREQUISITES FOR NETWORK SHARE" at page 52 for more details.
Enable this function, and enter the address of the PC, the folder being shared, and the user name and password
to access the PC. If the information is all correct, you'll see a check in the "Status" column, and you're ready to
go to "Trigger" → "Snapshot" for further configurations.
3.2.14 Network Failure Detection (For selected models only)
Configure this camera to check the network connection of other device periodically, and send notifications via
Email or FTP for disconnection events.
3.2.15 Cloud (For selected models only)
This function is used with Angelcam which is a 3
through its official website, www.angelcam.com. When the setup is completed, you can only see the live view of
the camera via its mobile app, Angelcam Viewer.
Before using this service, you need to enable the support of this camera here and choose the video profile used
for streaming. Then, go to
add a camera.
rd
party cloud service to easily connect our camera online
www.angelcam.com to register an account and follow its step-by-step instructions to
18