Hardware Kit Contents - Invacare Matrx SMH Manuel D'utilisation

TRD0247-E Split Mounting Hardware Installation, Rev 5.0 (Europe)_Layout 1 13/09/2012 10:35 AM Page 3

2.0 - Hardware Kit Contents

The Split Mounting Hardware has been uniquely designed to allow for mounting
of our MaTRx Series wheelchair backs when a rigidizer bar is installed between the
wheelchair's back canes. The easy to use split mounting hardware still maintains a
high degree of adjustability, while effectively eliminating any interference issues
experienced with our standard mounting hardware.
Note: the Split Mounting Hardware is not recommended for use with MaTRx-PB Heavy Duty backs)
Split Mounting Hardware Overview Drawing
(Right Side)
Figure 1.0
(Note: Right Ass'y Shown)
- 3 -