Sony WX-XB100BT Mode D'emploi page 28

APP NO DEVICE: The device with the application
installed is not connected or recognized.
 Make the BLUETOOTH connection and establish
the "Sony | Music Center" connection again
(page 14).
APP SOUND: A sound setting display of the
application is open.
 Exit the sound setting display of the application
to enable button operation.
OPEN SONY APP: The "Sony | Music Center"
application is not running.
 Launch the application.
SONY APP DISCNCTED: The application is
disconnected.
 Make the "Sony | Music Center" connection
(page 14).
For steering wheel remote control
operation:
ERROR: An error occurred during the function
registration.
 Register again from the function where the error
occurred (page 17).
TIMEOUT: The function registration failed due to a
timeout.
 Try completing the registration while [REGISTER]
is blinking (about 6 seconds) (page 17).
For firmware update operation:
ERROR: The updater is not stored in the USB
device.
 Store the updater in the USB device, then try
again (page 20).
NO DEVICE: The USB device containing the updater
is not connected or recognized.
 Make sure the USB device is securely connected.
 Disconnect the USB device, then connect the
device again.
UPDATE ERROR PRESS ENTER: Firmware update is
not completed properly.
 Press ENTER to clear the message, then try again.
During the update, do not turn the ignition to the
OFF position, nor remove the USB device
(page 20).
If these solutions do not help improve the situation,
consult your nearest Sony dealer.
If you take the unit to be repaired because of CD
playback trouble, bring the disc that was used at
the time the problem began.
28
GB