Installation - Sony WX-XB100BT Mode D'emploi

Cautions
 It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
 If airbags or any other shock-absorbing
equipment is in your car, contact the store where
you purchased this unit, or the car dealer, before

installation.

Note
Before attaching the double-sided tape , clean the
surface of the dashboard with a dry cloth.
Using the wired remote control
1
To enable the wired remote control, set
[STR CONTROL] in [STEERING] to [PRESET]
(page 17).
Installation
Removing the bracket
Before installing the unit, remove the bracket 
from the unit.
1
Insert both release keys  until they
click, and pull down the bracket , then
pull up the unit to separate.


Face the hook inwards.
Mounting the unit in the dashboard
For Japanese cars, see "Mounting the unit in a
Japanese car" (page 34).
CAUTION
Do not touch the left side of the unit when
removing from the dashboard. The heatsink on
the left side of the unit remains hot right after
use.
Mounting the unit with the supplied
bracket
Before installing, make sure the catches on both
sides of the bracket  are bent inwards 3.5 mm
( 5 / in).
32
1
Position the bracket  inside the
dashboard, then bend the claws outward
for a tight fit.

2
Mount the unit onto the bracket .

Note
If the catches are straight or bent outwards, the unit will
not be installed securely and may spring out.
Larger than
Catch
1
182 mm (7 /
4
Larger than
111 mm
(4 3 / in)
8

33
in)
GB