Sony MDS-JB980 Mode D'emploi page 50

Incomplete!
The S.F Edit (changing the recording level after
recording, Fade-in, Fade-out) operation was not
performed properly because the deck was moved
while recording was in progress or the MD is
damaged or dirty.
Initialize (flashing)
The Setup Menu settings have been lost.
Or the contents recorded by the timer have
disappeared over time and are not be available for
saving to disc, or Programme Play could not be
activated since the programme has disappeared
over time.
(The message flashes for about four seconds when
you turn on the deck by pressing ?/1.)
Name Full!
The naming capacity of the MD has reached its
limit (about 1,700 characters).
Net MD
The Net MD function is on. (If you attempt an
invalid operation at this time, "Net MD!" appears.)
Net MD NOW
You pressed the ?/1 during Check In or Check Out
execution. This may cause data damage, so be sure
to wait for Check In or Check Out to finish before
turning off the Net MD function and the MD deck.
No Change
While attempting to change the recording level
after recording, you pressed AMS or YES without
actually changing the recording level, so no change
was made.
No Disc
There is no MD in the deck.
No Name
The track or disc has no name.
Premastered
An attempt was made to record or edit to a
premastered MD.
50
GB
Push Stop!
You pressed an invalid key during MD operation.
Press x and perform the operation again.
S.F Edit!
You attempted to perform another operation while
in S.F Edit (changing the recording level after
recording, Fade-in, Fade-out) mode.
You cannot perform any other operations while in
S.F Edit mode.
(S.F) Edit NOW
You pressed ?/1 while in S.F Edit (changing the
recording level after recording, Fade-in, Fade-out)
mode.
If you turn off the deck while in S.F Edit mode, any
changes that you have made will not be made
properly. Finish the changes and leave S.F Edit
mode before turning off the deck. If you
accidentally turn off the deck while changes are
being made, press ?/1 while the message is
displayed.
Smart Space
The Smart Space Function is on (page 14).
Step Full!
The programme contains the maximum number of
tracks. You cannot add any more tracks.
TOC Reading
The deck is checking the TOC (Table Of Contents)
on the MD.
TrProtected
You cannot perform editing operations on protected
tracks (tracks checked out from a USB connected
computer, etc.) other than "Moving recorded
tracks" on page 30 and "Naming a track or an MD"
on page 30 using this deck.