Sony MDS-JB980 Mode D'emploi page 20

Other Operations
To
Stop play
Pause play
Resume play
after pausing
Go to the next or
a succeeding
track during play
Go to a
preceding track
during play
Go to the
beginning of the
current track
during play
Go to a specific
track while the
deck is stopped
Find a point in a
track
Eject the MD
1) Automatic Music Sensor
2) When you locate a point while monitoring the
sound.
3) When you locate by observing the time
indication.
Tips
• The MDLP indicator lights up when you select a
track recorded in LP2 or LP4 Stereo mode.
• To use headphones, connect them to the PHONES
jack. Turn PHONE LEVEL to adjust the
headphones level.
• When "– Over –" appears in the display, the MD has
reached the end while you're pressing M. Turn
AMS counterclockwise (or press .) or press m
to go back.
20
GB
Do the following:
Press x.
Press X.
Press H or X.
1)
Turn AMS clockwise (or press
> repeatedly).
Turn AMS counterclockwise (or
press . repeatedly).
Turn AMS counterclockwise (or
press . once).
Turn AMS (or press ./>
repeatedly) until the track number
you want to go to flashes in the
display, then press AMS or H.
Press down m/M during play
or play pause 3) . Release it when
you reach the desired point.
Press EJECT A after stopping
play.
• You can adjust the analogue signal level output to
the PHONES jack and the ANALOG OUT jacks.
1 While the deck is playing, press DISPLAY/
CHAR (or DISPLAY) repeatedly until the
line output adjustment display appears.
2 Turn AMS (or press LEVEL +/–
repeatedly) to adjust the output signal
level.
• You can use Setup Menu to adjust the analogue
output level.
1 While the deck is playing, press MENU/
NO.
2 Turn AMS (or press ./> repeatedly)
until "Setup?" appears, then press AMS or
YES.
3 Turn AMS (or press ./> repeatedly)
until "Aout" appears, then press AMS or
YES.
4 Turn AMS (or press LEVEL +/–
repeatedly) to adjust the output signal
level, then press AMS or YES.
2)
5 Press MENU/NO.
Note
When you eject the MD or turn off the deck, the
output level is reset to the factory setting (0.0 dB).
Playing a track by entering the track
number
Press the number button(s) on the remote
to enter the track number of the track you
want to play.
To enter a track number over 10
1 Press >10.
"-" equal to the number of digits for the number
of tracks recorded on the MD flashes.
2 Enter the corresponding digits.
To enter 0, press 10/0 instead.
Examples:
• To select track number 30 on an MD recorded with
50 tracks, press >10, then 3 and 10/0.
• To select track number 30 on an MD recorded with
200 tracks, press >10, then 10/0, 3 and 10/0.