Black & Decker VM1450 Mode D'emploi page 5

Intended use
Your Black & Decker vacuum cleaner has
been designed for dry vacuum cleaning
purposes. This appliance is intended for
consumer indoor use only.
Safety instructions
Warning! Read all safety
warnings and all instructions.
Failure to follow the warnings
and instructions listed below may
result in electric shock, fire and/or serious
injury.
• Read all of this manual carefully before
using the appliance.
• The intended use is described in this
manual. The use of any accessory or
attachment or the performance of any
operation with this appliance other than
those recommended in this instruction
manual may present a risk of personal
injury.
• Retain this manual for future reference.
Using your appliance
• Make sure that the appliance is switched
o before connecting to or
disconnecting from the power supply.
• Always take care when using the
appliance.
• Do not use the appliance outdoors.
• Never pull the power supply cord to
disconnect the plug from the socket.
Keep the power supply cord away from
heat, oil and sharp edges.
• If the power supply cord is damaged
during use, disconnect the appliance
from the power supply immediately. Do
not touch the power supply cord before
disconnecting from the power supply.
All manuals and user guides at all-guides.com
• Disconnect the appliance from the power
• Do not immerse the appliance in water.
After use
• Switch off and remove the plug from the
• When not in use, the appliance should be
• Children should not have access to stored
Inspection and repairs
• Before use, check the appliance for
• Do not use the appliance if any part is
• Have any damaged or defective parts
• Before use, check the power supply cord
• Do not use the appliance if the power
• If the power supply cord or mains plug is
supply when not in use, before fitting or
removing parts and before cleaning.
socket before leaving the appliance
unattended and before changing,
cleaning or inspecting any parts of the
appliance.
stored in a dry place.
appliances.
damaged or defective parts. Check for
breakage of parts, damage to switches
and any other conditions that may a ect
its operation.
damaged or defective.
repaired or replaced by an authorized
repair agent.
for signs of damage, ageing and wear.
supply cord or mains plug is damaged or
defective.
damaged or defective it must be repaired
by the manufacturer or its service agent
or a similarly qualified person in order to
avoid a hazard. Do not cut the power
supply cord and do not attempt to repair
it yourself.
ENGLISH
5