Télécharger Imprimer la page

Worx WG776E Mode D'emploi page 12

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
OPERATIOn
1. STARTING AND STOPPING
(See Fig. E1, E2)
wARNING! The blade continues
to rotate for a few seconds after the
machine is switched off. Allow the motor/
blade to stop rotating before switching "on"
again. do not rapidly switch off and on.
STARTING
1) insert safety key into the housing of the
switch box.
2) Slide the key to the right and hold in
position.
3) pull the lever bar towards the handle and
the mower will start.
4) Release the safety key.
STOPPING
Release the switch lever.
2. wORK MODE DIAL (See Fig. F)
Status1: QUIET mode
Select QUiET mode when mowing in
everyday conditions, removing approximately
20mm of grass at a time.
Status2: TURBO mode
12
Set the dial to TURBO mode when cutting
dense or overgrown grass.
3. BATTERy STATUS LED'S (See Fig. G)
NOTE: The Status LED's will indicate the
battery condition when the button on
the battery is pressed.
The LEd's constantly senses and displays the
battery condition as follows:
press the button "pOWERTEST" , the light
button is illuminated.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
battery is in a moderately charged condition.
When only one green light (
the battery charge is depleted.
Before using your new mower for the first
time, it is recommended that the unit be
charged overnight to ensure that the battery is
fully charged.
IMPORTANT
when only one light is illuminated,
Cordless lawn mower
All manuals and user guides at all-guides.com
) are illuminated, the
) is illuminated,
your battery is overly discharged, even
though the mower may still be capable
of cutting grass. Continuing to operate
your lawnmower with the battery in this
discharged condition may reduce the life
and performance of your battery.
4. ADJUSTING ThE CUTTING hEIGhT
(See Fig. h)
wARNING! Stop, release switch lever
and wait until the motor stops before
adjusting height. The blades continue to rotate
after the machine is switched off, a rotating
blade can cause injury.
CAUTION: Do not touch rotating
blades.
For the first cutting of the season, a high
cutting adjustment should be selected.
The lawnmower can be set to 5 cutting
heights between 20mm and 60mm. For this
purpose, move the cutting height adjustment
lever outwards then adjust to the preferred
position.
5. GRASS BAG FILLING INDICATOR
(See Fig. I)
To remind you immediately to empty when
the grass collection bag is full, the mower
provides an indicator on the top of bag to
show the collection status. And you can
follow as below:
Empty status: flap floats (a)
Fully status: flap falls down (b)
6. REAR DISChARGE (See Fig. J)
The mower provides a rear discharge
function, so that you can mower without bag
collection. The debris will be discharged from
the rear chute.
7. MOwING TIPS
NOTE: Always inspect area where
mower is to be used and remove all
stones, sticks, wire, metal and other
debris which might be thrown by the
rotating blade.
1. Mow across the face of slopes, never up-
En

Publicité

loading