Ducati Pro-I Evo Black Edition Mode D'emploi page 26

Brake adjustment
Adjusting the brake calliper
If the brake is too tight or too loose, use the hex wrench to loosen the
nut (A), then adjust the brake cable, (shorten the brake cable at the
top if it is too tight; if it is too loose, pull the brake cable downwards)
and then, retighten the nut (A). If the wire is too loose or too tight
even after following the first step, it may be necessary to adjust the
(fixed) brake pad by means of the wheel located on the opposite side;
use the hex wrench to move the brake pad (B) closer or further away
(see picture).
Check the correct alignment between the brake caliper and the disc.
Use screws C and D to adjust the position / alignment on the disc,
if necessary.
Make sure the electric scooter is turned off. Hold the handlebar stem with your hand, pull the lever, fold the stem towards
the footrest and fasten it.
Models: Pro-I Evo, Pro-I Evo SR, Pro-I Evo AS, Pro-I Evo Max SR
Closing: Switch off the electric scooter, unlock the
closing mechanism: press the red hook and pull the lever
outwards (see picture), move the handlebar stem inwards
and make sure it is locked.
Opening: Unlock the handlebar stem from the mudguard:
press the clip to release the handlebar, lift the handlebar
stem all the way and lock it in place by pushing the lever
inwards. Switch on the electric scooter.
7. Folding and carrying
Always carry the scooter with one or both hands holding
the handlebar stem.
25