Adjusting The Monitor Angle - Sony XAV-A1 Mode D'emploi

Preparations
The monitor slides out of the main unit.
Notes
• The card remote commander cannot be used for
opening up or closing the monitor.
• If movement of the monitor during opening or closing
has been impeded by the gear shift lever or another
obstacle, press OPEN/CLOSE again.

Adjusting the monitor angle

You can adjust the angle of the monitor for
best viewing.
Press ANGLE –/+ repeatedly.
The buttons adjust monitor position in
discrete steps.
+ button: Monitor is tilted backward.
– button: Monitor is tilted forward.
The adjustment is memorized, and the
monitor will move to the same angle the next
time it is opened up again after having been
closed.
Notes
• Do not move the monitor by hand.
• If OPEN/CLOSE was pressed while the monitor was
opening or closing, the monitor may not stop at the
original angle. In such a case, press ANGLE –/+ to
adjust the angle.
10
ANGLE –/+
Adjusting the monitor position
You can adjust the monitor position by sliding
it forward or backward while pressing SLIDE.
When the monitor cannot slide any more, the
monitor begins to slide in the opposite
direction. Press and hold SLIDE for 2 seconds
to slide the monitor back to the other
direction when the monitor is in halfway
through.
The adjustment is memorized, and the
monitor will automatically move to the same
position when it is opened up again.
Tilting the monitor ahead
In order to operate the button on the
dashboard easily, the monitor can be tilted
ahead.
Press TILT.
The monitor will be tilted ahead.
To return to the original position, press TILT
again.
Tip
If no operation is made for about 25 seconds, the monitor
will return to the original position.
SLIDE
TILT