TechniSat DIGITRADIO 602 Notice D'utilisation page 70

18.2 Internet settings
> Press the MENU button and then select [Main Menu > System Settings >
Internet Settings].
In this menu you will find some settings and information about the Internet
connection.
> Select Network wizard to establish a WLAN connection.
The network wizard shows you all the WLAN stations within range. Use
the / and OK buttons to select the WLAN network you recognise and
enter the password using the displayed keyboard. Then select
press the OK button. If the password entered is correct, a connection to
the network is now established. The signal bars
display indicate whether a connection exists.
To cancel the input, select
mistake, you can delete the last letter you entered by pressing
> If you want to establish a WPS connection instead of entering the password,
proceed as follows after selecting the WLAN network:
How you activate WPS on your router can be taken from its instruction
manual.
> Select [Press button] on the DIGITRADIO 602 after selecting the WLAN
network. Take note of the instructions on the display.
> Start WPS on your router by pressing the relevant button.
> If your router only supports the WPS PIN, select [PIN] on the DIGITRADIO
602 and take note of the PIN shown on the display. You then need to enter
the PIN in the router.
18.2.1 WPS connection
> Select [Internet settings > PBC WLAN set up] if your router has the WPS
function. This establishes a direct connection to the router without having to
enter the WLAN password.
How you activate WPS on your router can be taken from its instruction
manual.
> Start WPS on your router by pressing the relevant button.
18.2.2 More information about the network connection
> To find out more about the current connection select Show settings.
70
and press the OK button. If you make a
in the status bar of the
and
.