TechniSat DIGITRADIO 602 Notice D'utilisation page 54

7.3.2 Connecting the mains adapter
Ensure that the operating voltage of the power supply unit matches the
mains voltage before you insert it into the wall socket.
WARNING!
Do not touch the mains plug with wet hands; electric shock hazard!
CAUTION!
Route the mains cable in such a way that nobody can trip over it.
> Connect the supplied power adapter to the port marked DC-IN (24) on the
back of the DIGITRADIO 602. Then connect the power supply to the mains.
7.3.3 Inserting the batteries into the remote control
> Open the battery compartment on the back of the remote control by sliding it
in the direction of the arrow.
> Insert the batteries (2 x AAA 1.5 V) in accordance with the polarity indicated
in the battery compartment.
> Close the battery compartment lid carefully again and ensure that the lid
retaining tabs engage in the housing.
You will need 2 micro alkaline batteries, 1.5 V, LR03/AAA to operate the
remote control. Make sure the polarity is correct when inserting them.
- Replace batteries that are losing power in good time.
- Leaking batteries can cause damage to the remote control.
- If the device is not to be used for a prolonged period, remove the batteries
from the remote control.
- Important instructions for disposal: Batteries may contain toxic substances
that are hazardous to the environment. Therefore, it is imperative to dispose
of the batteries according to the legal provisions in force. Never dispose of
batteries in normal household waste.
7.4 General device functionality
Settings and functions can be carried out both using the buttons on the device and
with the remote control. The description of the operation in this instruction manual
refers to the buttons on the remote control.
54