CEMO KS-Mobil 400 l Manuel D'utilisation page 22

GB
4. Initial setup
1. Affix the enclosed stickers to the front of the
KS-Mobil 400 l.
Fig. 4.1: KS-Mobil 400 l labelling
Fig. 4.2: KS-Mobil 600 l / 980 l labelling on both sides
(front and rear)
A
UN 1203 for petrol
Hazard label
B
(flame on red background)
22
All manuals and user guides at all-guides.com
B
A
B
A
2. Fill the tank (see section 5.4).
Screw cap f onto filling connection. The contai-
ner is filled with a fixed filling connection. The
limiting value transmitter j must be connected.
The limiting value transmitter is factory-set to a
95 % filling.
The ventilation pipe must be installed in
order to fill the container.
3. Perform a test filling as described in section 5.5,
but hold the outlet manifold or delivery nozzle m
in the open filling opening f.
4. After completing the test filling, close the filling
opening tight using the cap.
►
The filling station is now ready for operation.
5. Operation
5.1 Storage
Do not expose the KS-Mobil to direct sunlight for
extended periods either during transport or when in
storage. Excessive heating can degrade the quality
of the high-grade plastic container.
If heating produces overpressure in the sealed
container, this overpressure will be released via the
safety valve i .
Suitable storage conditions:
• ambient temperatures from - 10 °C to + 40 °C.
• level surface
• canopy for storage outdoors
5.2 Loading the filling station
Risk of injury!
Door of the pump cabinet a must be
closed.
Important!
i
the ventilation pipe b must be removed
for loading/transport.
­ seal coupling c with blind cover
­ close the ball valve of the delivery line g