Sartorius ACCULAB ALC Série Mode D'emploi page 6

6
Connecting the Balance/Scale to AC Power/Safety Precautions
Use only original Acculab AC adapters:
– for Europe: 6971948
– for the U.S.: 6971947
§ Insert the right-angle plug into the jack
§ The AC adapter rated to Class 2 can be plugged into any wall outlet without
requiring any additional safety precautions
The ground is connected to the balance/scale housing, which can be additionally
grounded for operation.
Using a Non-Rechargeable/Rechargeable Battery
(for models ALC-810.2, ALC-2100.1, ALC-4100.1 and ALC-6100.1)
$ A non-rechargeable or rechargeable battery is not included with the equipment
supplied
Use only a commercially available non-rechargeable or rechargeable
!
9-volt battery
When using a rechargeable battery, always use an external charger to recharge
!
the battery
§ Lay the balance/scale on its side
§ Open the battery compartment: Lift the compartment cover
§ Insert the 9-volt (rechargeable) battery in the compartment
$ Make sure to connect the positive and negative poles correctly
All used batteries are classified as waste that requires special handling (not
!
"household" waste). Dispose of rechargeable batteries in accordance with the
applicable special waste disposal regulations.
§ Close the battery compartment: Press down on the cover until it clicks into place
– for the RSA: 6971949
– for Australia: 6971950