Operating; Delete Remote Control Settings - Evolu7 Link Guide D'utilisation

if in the process of setting operation, stop key timeout 20
seconds, the host will automatically exit the setup to return to
the disarmed state
Operating:【*】 + 【#】

Remote coding
All remote controls must be coded with the host for normal
remote control and operation.
In Settings state, first enter the address code [20] by host keypad,
then select remote number [1]~[8] and finally press [#] to confirm;
[Signal] always lights, LCD displays coding icon and press any
key to send a wireless signal on remote control to be coded; after
the host receives the signal, [Signal] light goes off, and voice
prompts: coding successfully, please enter instruction.
Settings:【20】【A】【#】
A means: [1]~[8] remote serial numbers; it could be
coded at most 8 remote controls .
Example:

operating

Operation:【20】【1】【#】
LCD display:

Delete remote control
Once remote control is deleted, no operation could be
performed on alarm
In Settings state, first enter [21] by keypad, then select remote
serial number to be deleted and finally press [#] to confirm;
[Signal] flashes once, and voice prompts: deleted successfully,
please enter instruction.
Settings method:【21】【A】【#】
A: [1] ~ [8] remote serial numbers; it could be coded at most
A remote control code in the position of the 1st
46