Password Recovery; Factory Defaults; Enter Setting; Exit Setting - Evolu7 Link Guide D'utilisation



Password recovery

If the password is lost or forgotten, please use the [Recover
password] command to recover password to original state.
In arm or disarm, press [0321456988] number keys on the host
keyboard, and finally press [#] key to confirm; Host [Signal] indicator
flashes once, and the speaker sound a long "beep". User password is
cleared, and it is recovered to the original [1234].
Engineering password is
Operating:【0321456988】【#】


Factory defaults

In Settings state, enter [0321456987]on the key directly, and then
press [#] to confirm; then all LED lights on the host are on for 2
seconds and the speaker sounds a long beep. All settings on the
host are cleared and return to original factory state.
Operating:【0321456987】【#】


Enter Setting

Only in setting state, function settings and operations could be
performed on the host.
In disarm state, enter four-digit [Password] with key pad and then
press [ # ] key to confirm; Host voice prompt: please enter
instruction, and [Set] indicator light will always light , entering
the system setting status. host's original factory engineering
password is [6666].
Operating:【Password】 【#】


Exit Setting

When the function is set up, or it is in the setting state ([SET]
indicators light forever),
press [*],[#] keys to exit setting mode, [SET] light is off, host
returns to disarm state.
You can set all functions continuously after enter
Just press [#], If you input error or command skipping. However,
[6666]
45
the settings.