Beurer ELLE MPE 70 Mode D'emploi page 16

8. cleaning
Important
If the device is only being used by one person, change the paraffin wax at regular intervals and
clean the paraffin bath whilst doing so.
If the device is being used by several people, the paraffin wax should be changed before each
treatment for reasons of hygiene.
• Pull the mains plug out of the socket.
• Take the protective grille out of the paraffin bath.
• Allow the paraffin wax to solidify overnight.
Warning
Do not use any sharp or pointed objects to remove the
wax block from the paraffin bath. You could damage or
scratch the paraffin bath.
• If the paraffin wax has solidified, press on one end
of the wax block and lift it out of the paraffin bath.
If the wax block cannot be removed easily, turn the
temperature controller to "warm" for ten minutes. Then
remove the mains plug and take the wax block out of
the paraffin bath.
• Then wipe the inside of the paraffin bath dry with a
clean towel.
Important
Never fill the paraffin bath with water in order to clean it.
• After cleaning, store the paraffin bath in a cool, dry and
dust-proof place.
9. Replacement parts and wearing parts
2 x 450 g of paraffin wax + 30 sheets 589.42*
*
Commercially available or from the corresponding service address (according to the service address list)
10. Disposal
Dispose of the unit in accordance with EC Directive 2002/96/EC – WEEE (Waste Electrical
and Electronic Equipment). If you have any questions, please contact the local authorities
responsible for waste disposal.
11. technical data
Model no.
Voltage supply
Output
Protection class
Dimensions (L x W x H)
Weight
Item and/or order number
MPE 70
230-240 V~50 Hz
83 W
II / , IPX0
33 x 25 x 18 cm
1 kg
16