Worx WG250 Mode D'emploi page 11

TOP CUTTING
Use a wide sweeping motion (See J). A slight
downward tilt of the cutting blades in the
direction of motion gives the best cutting
results.
SIDE CUTTING
When trimming the sides of the hedge, begin at
the bottom and cut upwards (See K), tapering
the hedge inward at the top. This shape will
expose more of the hedge, resulting in a more
uniform growth.
MAINTENANCE
CLEANING
REMOVETHE BATTERY PACK. Use a soft brush
to remove debris from all air intakes and cutting
blade.
Wipe the surface with a dry cloth.
Warning: Never use water for cleaning
your trimmer. Do not clean with
chemicals, including gasoline, or solvents as
this may damage your trimmer.
LUBRICATING THE CUTTING BLADE
For easier operation and longer life, lubricate
the cutting blades before and after each use.
Before lubricating, make sure the battery is
removed from the trimmer. Apply oil between
the two blades periodically (See L).
Your trimmer should be stopped, disconnected
and oiled occasionally during use.
AT THE END OF THE CUTTING SEASON
Clean your trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the trimmer for any worn or
damaged parts.
STORING YOUR HEDGE TRIMMER
a) Charger and bracket mounting
To attach the charger onto the wall-mount
bracket, insert the charger legs into the slots in
the bracket and push the charger towards the
left, making sure the legs are fully insert into
the slots (See M.1).
To remove the charger from the bracket, press
the release button and push the charger out of
Cordless Hedge trimmer
CTC-WG250-M-060417.indd 11
All manuals and user guides at all-guides.com
the slots.(See O). Be careful not to trap your
finger.
Before you attach the wall-mount bracket to
the wall, make sure to check the charger cable
length to the wall socket. Attach the wall-mount
bracket to the wall with the five screws provided
(See M.2).
Tighten all five screws securely. Carefully check
the bracket after mounting to make sure that no
movement can occur during use.
Warning: Always make sure your wall-
mount bracket is securely mounted to the
wall. Failure to do so could result in an accident,
resulting in possible serious personal injury.
b) Storing your hedge trimmer
Insert the hedge trimmer into blade sheath,
then store the hedge trimmer into the wall
mount bracket as illustrated (See N.1)
c) Wall-mount charging
The charger can be attached in the wall-mount
brackets.The battery pack can be charged inside
the wall-mount bracket. (See N.2)
Store in a dry place where your trimmer can be
protected from damage.
WARRANTY STATEMENT
30 DAY Satisfaction Guarantee
If for any reason you are dissatisfied with any
WORX product, you can return the product
along with proof of purchase within 30 days for
a full refund.
If your WORX product becomes defective due
to faulty materials or workmanship within the
specified warranty period of;
• 24 months for DIY and light trade use, from
the date of purchase.
We guarantee to repair or replace all defective
parts free of charge, repair products subject
to fair wear and tear, free of charge, or at our
discretion, replace the unit free of charge
to ensure minimum inconvenience to the
11
ENG
2006-4-20 14:53:30