Publicité
Les langues disponibles
Les langues disponibles
Replacement Filter Assembly
1. Carefully slide the filter over the filter
cage, lining up hole in filter with
threaded stud and sliding it over the
center ring covering the 3 slots until the
filter stops against the lid.
2. Place filter nut onto threaded screw and
tighten it down. Finger tighten only.
NOTE: Lever of filter nut should be away
from filter as shown.
IMPORTANT: Do not overtighten as this
may deform or crack the filter cage.
To Store Your Accessories
1. Slide extension handles and accesso-
ries on to posts of the caster feet for
storage.
2. To remove handles and accessories,
lightly rotate and pull upward.
Vac Assembly
1. Line up vacuum port above drum label.
2. Place lid on top of drum with the han-
dles snug against the drum channel.
3. Be sure lid completely covers the top of
the drum so leakage does not occur.
4. Make sure that the locking tabs are
snapped in place to prevent the lid from
coming off.
All manuals and user guides at all-guides.com
5
Power Head
Vacuum Port
Drum
Channel
Filter Nut
Filter
Filter
Cage
Push
Down
Pull
Out
Flexible
Locking
Tab
Publicité
