Toro HDX SD 2000 Serie Manuel De L'utilisateur page 61

1. Blade
3. Repeat this procedure until the blade is
balanced.
Installing the Blades
1. Install the blade onto the spindle shaft
78).
Important:
The curved part of the blade
must point upward toward the inside of the
mower to ensure proper cutting.
2. Install the curved washer and blade bolt
78).
Note:
Install the curved-washer cone toward
the bolt head.
3. Torque the blade bolt to 115 to 150 N∙m (85 to
110 ft-lb).
Adjusting the Side-to-Side
Leveling and the Blade
Slope
Check to ensure that the mower deck is level any time
you install the mower or when you see an uneven cut
on your lawn.
Check the mower deck for bent blades prior to
leveling, and remove and replace any bent blades;
refer to the Checking for Bent Blades (page 57)
continuing.
Level the mower deck side-to-side first; then you can
adjust the front-to-rear slope.
Requirements:
•
The machine must be on a level surface.
•
All tires must be properly inflated; refer to
the Tire Pressure (page
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Check the tire pressure in the drive tires. Refer
to Checking the Tire Pressure (page
Figure 80
2. Balancer
47).
47).
4. Position the mower deck in the transport-lock
position.
5. Carefully rotate the blades from side to side.
6. Measure between the blade tip and the flat
g000553
surface
not within 5 mm (3/16 inch), adjust the leveling;
continue with this procedure.
(Figure
(Figure
1. Blades side to side
2. Blade tip
before
7. Check the front-to-rear blade level
Ensure the front blade tip is lower than the rear
blade tip as shown in the block height and rake
table. If it needs adjustment, continue with this
procedure.
Checking
59
(Figure 81). If the measurements are
Figure 81
3. Measure from the tip of the
blade to the flat surface
here.
g229303
g229305
(Figure 82).