Toro HDX SD 2000 Serie Manuel De L'utilisateur page 54

1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Push the deck-lift pedal, remove the height-of-cut
pin, and lower the mower deck to the ground
4. Raise the rear of the machine up and support it
with jack stands (or equivalent support) just high
enough to allow the drive wheels to turn freely.
5. Remove the electrical connection from the seat
safety switch, located under the bottom cushion
of the seat.
Note:
The switch is a part of the seat assembly.
6. Temporarily install a jumper wire across the
terminals in the connector of the main wire
harness.
7. Start the engine, run it at full throttle, and
disengage the parking brake.
Note:
Before starting the engine, ensure that
the parking brake is engaged and that the
motion-control levers are out. You do not have
to be in the seat.
8. Run the machine at least 5 minutes with the
drive levers at full forward speed to bring the
hydraulic fluid up to the operating temperature.
Note:
The motion-control levers must be in
neutral while you are making any adjustments.
9. Bring the motion-control levers into the N
position.
10. Check and ensure that the control-plate tabs
touch the return-to-neutral plates on the
hydraulic units.
11. Adjust the pump-control-rod lengths by rotating
the nut in the appropriate direction until the
wheels slightly creep in reverse
1. Nut
2. Stationary plate
3. Control plate
12.
EUTRAL
13.
14.
15.
(Figure 68).
16.
17.
52
Figure 68
Move the motion-control levers to the R
position and while applying slight pressure to
the lever, allow the reverse-indicator springs to
bring the levers back to neutral.
Note:
The wheels should stop turning or slightly
creep in reverse.
Note:
You may need to remove the
motion-control cover to gain access.
Shut off the machine.
Remove the jumper wire from the wire harness
and plug the connector into the seat switch.
Remove the jack stands.
Raise the mower deck and install the
height-of-cut pin.
Check and ensure that the machine does
not creep in neutral with the parking brake
disengaged.
g036753
4. Return-to-neutral plate
5. Tabs touching return to
neutral plate
EVERSE