Toro Z Master Professional 7000 Serie Manuel D'utilisation page 39

Maintenance
Maintenance Safety
WARNING
While maintenance or adjustments are being
made, someone could start the engine.
Accidental starting of the engine could
seriously injure you or other bystanders.
Remove the key from the ignition switch and
engage parking brake before you do any
maintenance.
WARNING
The engine can become very hot. Touching a
hot engine can cause severe burns.
Allow the engine to cool completely before
service or making repairs around the engine
area.
•
Park machine on level ground, disengage drives,
set parking brake, stop engine, and remove
key. Wait for all movement to stop and allow
the machine to cool before adjusting, cleaning
or repairing. Never allow untrained personnel to
service machine.
•
Disconnect battery before making any repairs.
Disconnect the negative terminal first and the
positive last. Reconnect positive first and negative
last.
•
Keep the machine, guards, shields and all
safety devices in place and in safe working
condition. Frequently check for worn or
deteriorating components and replace them with
the manufacturer's recommended parts when
necessary.
WARNING
Removal or modification of original
equipment, parts and/or accessories
may alter the warranty, controllability,
and safety of the machine. Unauthorized
modifications to the original equipment or
failure to use original Toro parts could lead
to serious injury or death. Unauthorized
changes to the machine, engine, fuel or
venting system, may violate applicable
safety standards such as: ANSI, OSHA and
NFPA and/or government regulations such
as EPA and CARB.
WARNING
Hydraulic fluid escaping under pressure
can penetrate skin and cause injury. Fluid
accidentally injected into the skin must be
surgically removed within a few hours by
a doctor familiar with this form of injury or
gangrene may result.
– If equipped, make sure all hydraulic
fluid hoses and lines are in good
condition and all hydraulic connections
and fittings are tight before applying
pressure to hydraulic system.
– Keep body and hands away from
pinhole leaks or nozzles that eject high
pressure hydraulic fluid.
– Use cardboard or paper, not your hands,
to find hydraulic leaks.
– Safely relieve all pressure in the
hydraulic system by placing the motion
control levers in neutral and shutting off
the engine before performing any work
on the hydraulic system.
WARNING
Fuel system components are under high
pressure. The use of improper components
can result in system failure, fuel leakage
and possible explosion.
Use only approved fuel lines and fuel filters
for high pressure systems.
•
Use care when checking blades. Wrap the
blade(s) or wear gloves, and use caution when
servicing them. Only replace damaged blades.
Never straighten or weld them.
•
Use jack stands to support the machine and/or
components when required.
CAUTION
Raising the machine for service or
maintenance relying solely on mechanical
or hydraulic jacks could be dangerous.
The mechanical or hydraulic jacks may not
be enough support or may malfunction
allowing the machine to fall, which could
cause injury.
Do not rely solely on mechanical or
hydraulic jacks for support. Use adequate
jack stands or equivalent support.
37