Cattini Oleopneumatica YAK 215/N Instructions Pour L'utilisation Et L'entretien page 16

CHECK THE OIL LEVEL CHECK THE OIL LEVEL
IMPOR IMPORT T ANT ANT: the maximum quantity of oil in this jack is 1.2 L. Compatible oil: ATF DEXRON IID
Please follow the steps listed here to check the oil level:
1. Bleed off the air (see procedure in the next section)
2. Position the jack horizontally with the pistons down
3. Undo the screw, POS. 24 A00337 POS. 24 A00337
4. If, once this screw has been undone, no oil comes out it means the level is too low. Add oil in this case. The level must
be at the height of the small bolt on the side of the tank, under the casing.
5. If oil does come out, let the excess quantity drain off until the right level is reached (see point 4).
AIR BLEEDING AIR BLEEDING
Each time the jack is serviced, with parts connected to the tank or motor pump removed and refitted, it is advisable to
bleed off all air.
Bleeding phases:
1. Position the jack on the workbench
2. Operate the raising control to allow the pistons to come to a fully extended position
3. Operate the raising control again for 2 seconds until the pistons lock in place
4. Make sure the pistons are now locked in place and cannot be rotated
5. Operate the lowering control until the pistons begin to come down
6. Ensure that the pistons can be rotated now. Remove the cover and close the cock
7. Turn the jack over on its handle, as illustrated in the drawing DWG. 16
8. Loosen (NEVER unscrew it completely!) Loosen (NEVER unscrew it completely!) the grub screw
all the air out, until hydraulic fluid starts flowing out. When finished, tighten the grub screw
9. Position the jack back on the base and open the cock
10. Operate the lowering control to get the pistons to fully retract.
11. Check the hydraulic fluid level
12. Try to operate the jack without any load. If the pistons do not lower smoothly, repeat the bleeding procedure at
least 2 or 3 times
MAINTENANCE RESER MAINTENANCE RESERVED T
ENGINEER ENGINEER
Having to carry out maintenance or overhauling, use exclusively genuine spare parts to ensure the utmost reliability for the
jack.
PROBLEMS PROBLEMS
Solutions
THE MOT THE MOTOR WILL NOT ST OR WILL NOT STAR
- Check that the air supply line is not choked.
- The outside seals fitted on the piston,
both the cylinder and the ram.
16
(see DWG. 15 DWG. 15)
VED TO A PROFESSIONALL O A PROFESSIONALLY QUALIFIED
ART T , OR IT RUNS BADL , OR IT RUNS BADLY Y . .
POS. 10 - A00423 POS. 10 - A00423
POS. 17 A00337 POS. 17 A00337 and push the pistons manually to allow
POS. 9 A00542 POS. 9 A00542
Y QUALIFIED
are worn. Replace them (kit KMYAK215/N) and lubricate
POS. 9 A00542 POS. 9 A00542
POS. 17 A00337 POS. 17 A00337
EN EN