Publicité
Les langues disponibles
Les langues disponibles
Replacing the handle on the KUDD01SSSS
1
To protect panel from scuffing, remove top foam packaging
.
and place on a flat surface. If top foam packaging is not
available, any material that can keep the panel from scuffing
will suffice.
Front of drawer
pin
Pin
4
Lay the panel, handle side down, on the foam packaging to
.
prevent scuffing the panel.
Loosen, but do not remove the fasteners. Turn fasteners
5
.
approximately 6 rotations.
6
Gently lift the panel. Gravity will separate the handle from the
.
panel. Do not remove the fasteners.
7. With slight thumb pressure on each fastener, lift the panel
vertically with the edge sitting on the foam.
8. With thumb pressure on one fastener, align the handle and
tighten the fastener finger tight (about 2-3 turns).
9
Repeat step 8 with the opposite end of the handle.
.
10
Once the handle is in place, lay the panel back on the foam.
.
11
Finish tightening the fasteners.
.
12
Reinstall the front panel on the dishwasher by reversing
.
steps 2 and 3 of "Replacing the handle on the KUDD01SSS"
section.
2
2
Open the dishwasher drawer
.
and remove the front panel by
pulling the pins on both sides
straight out with a pair of
needle-nose pliers.
3
Gently pull the bottom of the
.
panel away from the
dishwasher and then pull
down.
Publicité
