Adding Fuel / Heating At Nominal Thermal Output; Adding Fuel / Heating At Nominal Thermal; Output Tula Standard; Output Tula Direct Vent Stove - HASE Tula Mode D'emploi

Lighting the Fire Tula direct vent stove
Procedure
Completely open Pull secondary air
secondary air slider all the way out
Open warming up slider Push warming up
slider upwards
Pile up any remaining ash Open fi re box door
and unburned charcoal
into the centre of the
combustion chamber
Place 2-3 small logs into
the middle of the fi re box;
stack kindling/ignition
material and approx. 0.5 kg
of dry wood chips on top
Light the kindling/ Close fi re box door
ignition material.
Tab. 2
82

15. Adding Fuel / Heating at Nominal Thermal Output

Position of Control
More fuel should be added to the fi re when the fl ames from
Elements
the previous burning off phase have just gone out.
15.1 Adding Fuel / Heating at Nominal Thermal Output
Tula Standard
When the fi re is in its fi nal state, bring the fi re box in the
warming up position for approximately 5 to 10 minutes
(see fi g. 6 on previous page).
Afterwards put the secondary air slider in teh required
position.
Adding Fuel / Heating at Nominal Output
Procedure
Adjust secondary air
Add two logs weighing
approx. 1.2 kg in total.
Place logs with the end to
the front of fi re box. Only
add a single layer of fuel.
Tab. 3
15.2 Adding Fuel / Heating at Nominal Thermal Output
Tula direct vent stove
Adjust secondary air
Close warming up slider
Position of
Control Elements
Set secondary air slider to
position 4-5
Add two logs weighing
approx. 1.2 kg in total.
Place logs with the end to
the front of fi re box. Only
Open fi re box door
add a single layer of fuel
Tab. 4
Close fi re box door (Fig 7)
Adding Fuel / Heating at Nominal Output
Procedure Position of
Control Elements
Set secondary air slider to
position 4-5
Push warming up slider
downwards
Open fi re box door
Close fi re box door