Lighting The Fire; Lighting The Fire Tula Standard; Lighting The Fire Tula Direct Vent Stove - HASE Tula Mode D'emploi

unless absolutely necessary. Make sure the
room is well-ventilated and open the windows
and outside doors. If needed, use a fan for
faster air circulation.
If the maximum temperature is not reached during the fi rst
heating operation, you may notice an odour for a short period
of time the next time the stove is used as well.

14. Lighting the Fire

The fi ring up phase should be as short as possible, since
higher emissions can occur during this phase.
The slider settings described in Table 1 and 2 are recommen-
dations that were determined under conformance testing con-
ditions, in compliance with the relevant standard. Depending
on the weather conditions and the draught capability of your
chimney, accordingly adjust the slider positions for your Tula to
the local conditions.
NOTE!
The Tula may only be operated when the fi re
box door is closed; the fi re box door may
only be opened to add fuel.
WARNING!
Never use spirits, petrol, or other fl ammable
fl uids to light the stove.

14.1 Lighting the Fire Tula Standard

NOTE!
When lighting the stove, leave the fi re box
door handle (fi g. 6) in the warming-up position
for about 5 minutes, which prevents water va-
pour from condensing on the fi re box windows.
Please make sure to lock the door afterwards.
fi g. 6 fi g. 7

14.2 Lighting the Fire Tula direct vent stove

Open Open
Shut Shut
fi g. 8
WARNING!
The warming up slider (fi g. 8) may only be
opened during the warming up phase. Always
be sure to close it again after the warming up
phase.
Lighting the Fire Tula Standard
Procedure Position of Control
Elements
Completely open Pull secondary air
secondary air slider all the way out
Pile up any remaining ash
and unburned charcoal
into the centre of the
combustion chamber
Place 2-3 small logs into Open fi re box door
the middle of the fi re box;
stack kindling/ignition
material and approx. 0.5 kg
of dry wood chips on top
Light the kindling/ Put fi re box door in the war-
ignition material. ming up position (fi g. 6).
Wait about 5 minutes
and then close the fi re box
door completely (fi g. 7).
Tab. 1
81