Lighting The Fire; Adding Fuel / Heating At Nominal Thermal Output - HASE Sendai Pro 135 Manuel D'utilisation

this process unless absolutely necessary.
Make sure the room is well-ventilated and
open the windows and outside doors. If
needed, use a fan for faster air circulation.
If the maximum temperature is not reached during
the first heating operation, you may notice an odour
for a short period of time the next time the stove is
used as well.
7.

Lighting the Fire

The firing up phase should be as short as possible,
since higher emissions can occur during this phase.
The slider settings described in Table 1 are rec-
ommendations that were determined under con-
formance testing conditions, in compliance with
the relevant standard. Depending on the weather
conditions and the draught capability of your chim-
ney, accordingly adjust the slider positions for your
Sendai to the local conditions.
NOTE!
The Sendai may only be operated when
the fire box door is closed; the fire box
door may only be opened to add fuel.
WARNING!
Never use spirits, petrol, or other flamma-
ble fluids to light the stove.
CAUTION!
The door handle can become hot during
operation. When adding more wood, pro-
tect your hands with the oven gloves in-
cluded.
Lighting the Fire
Procedure Position of Control
Elements
Switch air slider to the Completely remove the air
heating-up position. slider by holding on to the
notches on the sides.
Pile up any remaining ash
Delhi
and unburned charcoal
into the centre of the
combustion chamber.
Place 4 small pieces of
wood with an approx. Ø of
3-6 cm and max. 2,5 kg in
the middle of the burning
chamber. Layer these
cross-wise on top of each
other. Place approx. 0.5 kg
of wood shavings on top
as a firelighter.
Light the kindling/ignition
material.
Stop the heating phase Push the air slider in until
as soon as the fuel is the notches on the sides
completely ignited. are no longer visible.
Tab. 1
8. Adding Fuel / Heating at Nominal
Thermal Output
More fuel should be added to the fire when the
flames from the previous burning off phase have just
gone out.
Adding Fuel / Heating at Nominal Output
Procedure Position of
Control Elements
Adjust the combustion air. Set air slider on position
between 2 and 3.
Add two logs weighing
approx. 1.5 kg total, place
them as shown in the
picture. Only add one layer
of fuel.
Tab. 2
CAUTION!
Please ensure that the logs are inserted
with sufficient distance (at least 5 cm)
from the furnace window.
The air slider must not be left in the heat-
ing-up position once the warming up
phase is complete.
GB
47