Adding Fuel / Heating At Nominal Thermal Output; Heating With Brown Coal Briquettes; Banking The Fire And Raising The Temperature; Emptying The Ash Drawer - HASE Como Mode D'emploi

7. Adding Fuel / Heating at Nominal Thermal Output
More fuel should be added to the fire when the flames from
the previous burning off phase have just gone out.
Adding Fuel / Heating at Nominal Output
Procedure
Adjust primary and
secondary air.
Close fire grate.
Add two logs weighing approx.
1,7 kg in total. Place logs with
one end to the front of fire box.
Only add a single layer of fuel.
Tab. 2
(I)
fig. 4
30
8. Heating with Brown Coal Briquettes
Wood should be used for the warming-up phase and when
adding fuel for the first time, see "Warming-up Phase". As
soon as a basic glowing firebed is reached, place 2-3 brown
coal briquettes on the grate in the middle of the firebox, kee-
ping a finger's width between the briquettes, and use the
Position of
following procedure and settings:
Control Elements
Close primary air slider (I),
set secondary air slider (II)
between position 2 and 3.
(fig. 4)
Push in fire grate slider.
Open primary air completely.
Adjust secondary air.
Place 2 briquettes onto the
grate.
Open fire grate.
Tab. 3
(II)
fig. 5
Heating with Brown Coal Briquettes
Procedure Position of
Control Elements
Pull primary air slider all the
way out (fig. 5)
Set secondary air slider to
position 2. (fig. 5)
Pull out fire grate slider.
(I)
(II)
9. Banking the Fire and Raising the Temperature
Keep the stove set as described above until the brown coal
briquettes are thoroughly burnt. Then close the primary air (I)
and the fire grate. Slide the secondary air slider (II) to position
2/3.
CAUTION!
While the stove is in operation, the secondary
air slider should never be completely closed.
To raise the temperature of the fire, stir up the rest of the glow-
ing embers with the fire grate slider. Open the primary air (I)
and add new logs to the fire.
10. Emptying the Ash Drawer
As a safety precaution, please make sure to wait until the
ashes are cold before you dispose of them. While the ash
collects during the fire, the lid is located under the ash drawer.
Remove both the ash drawer and the lid located underneath
it. Slide the lid onto the ash drawer so that it is closed; this
prevents ashes from flying around, which in turn means your
home stays clean. To place the ash drawer back into the stove,
proceed in the reverse order.
CAUTION!
Piled up ashes can impair or even block the
supply of primary air supply to the stove.Please
ensure that the air supply path for the primary
air between the ash drawer and the bottom of
the ash compartment remains clear.