Publicité
Les langues disponibles
Les langues disponibles
W 570 Flexio
Problem
Coating material
causes "paint tears"
Too much fog of
coating material
(Overspray)
Width of paint spray
cannot be adjusted
Paint in the
ventilating hose
Poor covering
capacity on the wall
24. Technical Data
Max. viscosity (Interior wall paint/Wall Extra
I-Spray spray attachment):
Power source:
Power consumption:
Atomizing output:
Max. flow rate (Interior wall paint/Wall Extra
I-Spray spray attachment):
Protection Class:
Sound pressure level*:
Sound pressure output*:
Oscillation level*:
Weight:
* Measured in accordance with EN 60745-1
Cause
•
Too much coating material
applied.
•
Distance to the object too large
•
Too much coating material
applied
•
Amount of air too high
•
Adjustment ring is not connected
to the peg on the air cap
•
Air screen is clogged up
•
Diaphragm soiled
•
Diaphragm defective
•
Spray material is too cold
•
Highly absorbent surface or paint
with poor covering capacity
•
Distance too large
Technical Data
Remedy
➞ Turn material volume
adjusting screw to the
left (-)
➞ Reduce distance
➞ Turn material volume
adjusting screw to the
left (-)
➞ Decrease air quantity
(Level: Wood & Metal
)
➞ Connect adjustment
ring and peg
➞ Disassemble and clean
➞ Clean the diaphragm
➞ Replace the diaphragm
➞ The material you are
spraying should be at
room temperature
➞ Cross spray (Fig. 11)
➞ Closer to the object
4000 mPas
230 V
, 50 Hz / 240 V
~
630 W
/ 660 W
100 W (min), 200 W (max)
500 ml/min
I
74 dB (A); Uncertainty K = 4 dB
87 dB (A); Uncertainty K = 4 dB
< 2.5 m/s²; Uncertainty K = 1.5 m/s²
1.9 kg
GB
, 50 Hz
~
35
Publicité
